I’ve noticed homeowners are especially intimidated when it comes to a mobile home ceiling. If you know your way around a toolbox and have had a few construction projects under your belt you should be able to replace your mobile home ceiling with drywall as long as you have some help and/or the right tools.
Replacing mobile home ceilings is a difficult topic to try to cover because there are so many variables but we’ve pulled together a few good tips that should help you replace your mobile home ceilings with drywall.
In many cases, you could and should place the new ceiling over the original gypsum ceiling panels (assuming they are healthy).
If you are leaving the original ceiling on you will need to use Furring Strips.
Furring strips are usually 1″x3″ or 1″x4″ boards that are attached to the ceiling perpendicular to the trusses so new ceiling material can be screwed, stapled, and glued to it. Furring strips simply adds more points of contact for the drywall or ceiling panel.
This illustration shows new drywall installed over the old ceiling using 1×3″ furring strips. (Source: The Family Handyman)
Shims are used to get the furring strips level and even.
To remove an original ceiling panel from a mobile home, you first want to protect everything under the ceiling. If mold or mildew is possible, you want to wear gloves, safety glasses, and a mask.
Of course, you’ll need to remove all the additions to the ceiling such as the light fixture, trim, battens or strips that cover the seams, and the the fake beams.
If you have beams, you’ll need to remove them before you get to the gypsum paneling. Those beams are usually just 3-sided “boxes” screwed directly into a truss sitting above it. Unscrewing and pulling it down with a pry bar is the easiest way.
Once you have the trim, battens, and false beams removed you’ll want to start taking the rosettes out of the panels as you go from one panel to the next.
If you have a ceiling with the glued splines you’ll have to pull each of the splines off and then pull out all the staples. Fair warning, there are usually a ton of staples.
Next, you cut the ceiling panels around the perimeter of the walls. Ceiling panels get attached to trusses first and then hoisted onto the home so the panel is sandwiched between the top of the wall and the bottom of the roof truss. If you can dig the old ceiling out go ahead and do it so you can use that small space as a ledge for the new ceiling. However, it’s not necessary.
At this point, you should be able to remove the ceiling in sections. Using a crowbar to push up between the trusses and then gently pulling down on the panel should get the job done quickly. What you are trying to do is loosen the adhesive that is used to glue the ceiling panels to the roof truss. Be easy, you don’t want to damage the insulation or trusses.
The following images are from Frugal Farm Wife of their mobile home remodeling project.
Experts Recommend Homeowners Add New Insulation in the Roof Cavity When Replacing Mobile Home Ceilings
If you are replacing a mobile home ceiling you’ll want to consider replacing the insulation in the attic. It’s a must-do, to be honest. There’s really no better time and new insulation can absolutely save money on heating and cooling. It’s not often you have access to your mobile home’s attic space so take advantage of it.
Insulation professionals can drill out a plug between every truss in the original ceiling and blow the new insulation and then replug the hole. It’s aptly called the drill and plug process and it’s worth every penny, especially in mobile homes that are over 30 years old.
amzn_assoc_tracking_id = “mobhomliv-20”; amzn_assoc_ad_mode = “manual”; amzn_assoc_ad_type = “smart”; amzn_assoc_marketplace = “amazon”; amzn_assoc_region = “US”; amzn_assoc_design = “enhanced_links”; amzn_assoc_asins = “1880120143”; amzn_assoc_placement = “adunit”; amzn_assoc_linkid = “d22c1b0194f99fbda1404532663e2245”;Blowing insulation into the roof cavity is the most effective and economical method for adding insulation to the manufactured home’s roof assembly.
John Krigger, Your Mobile Home
Older mobile homes usually have blown-in insulation in the attic if there’s any at all.
Most manufactured home factories blow loose-fill insulation into the attic. However, transporting, settling, condensation and even critters can move the loose insulation around which leaves naked spots. Plus, there are much better insulation products available nowadays.
The image below is also from Frugal Farm Wife and shows a single wide that just had its original ceiling panel removed. You’re seeing the vapor barrier with the insulation above. The home has better insulation than many older mobile homes though there is noticeable damage from condensation or water.
The owners replaced all the insulation and installed a new drywall ceiling.
There are many different recommendations regarding the right thickness of drywall for a mobile home ceiling. You’d think it would be a fairly universal thing but nothing is ever easy when a mobile home is involved.
The main issue with using drywall on mobile home ceilings is its weight. Older mobile homes with smaller trusses that are 24″ apart cannot handle too much weight.
If your trusses are 24″ apart and you do not want to reinforce them you can use the Sheetrock Ultralight Panels.
Drywall is available in 4-foot by 8-foot panels and four basic thicknesses: 1/4 inch, 3/8 inch, 1/2 inch, 5/8 inch. The thicker the drywall the heavier it will be. Therefore, you do not want thick drywall on your ceiling.
A sheet of 1/4″ thick drywall that is 4′ x 8′ weighs approximately 38.4 lbs.
Drywall that is 3/8″ thick and 4’x8′ weighs 44.8 pounds.
One-half inch thick (1/2″) thick drywall weighs 1.6 pounds per square foot so a 4-foot by 8-foot sheet weighs a total of 51.2 pounds per panel or sheet.
Drywall that is 5/8″ thick is, of course, a little heavier, at 2.31 pounds per square foot or 73.92 pounds per sheet which is entirely too much for mobile home ceilings.
The 1/2″ thick 4’X8′ Lightweight panels weight approximately 38.4 lbs.
1/2″ thick drywall is the most recommended for mobile home ceiling replacements. assuming the trusses can handle it. If not You will need to reinforce the trusses and add furring strips to give the drywall a way to be screwed in every 12 as recommended.
SHEETROCK UltraLight Panels are ideal for use on ceilings with up to 24-inch on-center framing and water-based texture, presenting potential cost-savings when used as a replacement for 5/8-inch type X board used on ceilings or 1/2-inch interior ceiling board. The panels are available in standard lengths, including 8-, 10-, 12-, 14- and 16-foot panels in 48- and 54-inch widths.
Drywall is available in a variety of lengths and the least amount of joints you have the least amount of headaches. The width is always 4-foot but you can get drywall as long as 14 foot. One sheet to go across the entire width of a single wide is perfect, but a bit difficult to handle.
A 10′ long panel is a little easier to maneuver and will still reduce the number of joints.
Drywall is one of the best materials to replace a ceiling in a mobile home but installing it on to a mobile home ceiling is a literal pain in the neck.
It’s not so much the drywall that is so expensive but all the tools and other stuff you need for it. To run down some quick numbers:
Besides your basic tools needed for mobile homes and as shown above and the materials list you have to buy, you’ll probably need at least one of the following. Luckily, you can rent or borrow these.
You’ve got your drywall and all the tools and materials and you are ready to roll. Hanging drywall is fairly cut and dry (it’s the taping and mudding that can get make you or break you).
If you watch this video you’ll see how the homeowner of a 1989 double wide added sister joists to the original trusses to give it enough stability and strength to handle the 3/8″ drywall:
Note: Unfortunately, the guy in the video below has negative opinions about mobile homes but the video is a good visual resource and I appreciate the information. I think it will help homeowners understand how thier roof is constructed and how to reinforce the trusses:
To reinforce the trusses to withstand the weight of the drywall the owner added 2″x4″s beside the original trusses (the metal is holding it up):
Bill Sabin is restoring a vintage Kropf mobile home and shares the process on our new Facebook group Mobile Home Living: Remodels and Repairs – come join us! It’s a great group of mobile homeowners. You can see he has used a single piece of sheetrock to span the entire width of the ceiling. His next step is to tape and mud.
If you haven’t done drywall before I do urge you to hire it out or find someone to help that has experience if you want the best results. It’s not that it’s a difficult job but it’s one where experience makes all the difference.
A bad drywall finish cannot be hidden by texture. In fact, texture oftentimes makes the little mistakes appear much bigger.
Having sheetrock ceilings and walls in a mobile home creates a clean and beautiful canvas.
Thankfully, it’s not difficult to find videos and experts knowledge online. Here are some of the best tips we’ve found for drywalling a mobile home ceiling:
Textured ceilings are not as fashionable as they used to be. In fact, many homeowners in our Mobile Home Living: Remodels and Repairs Facebook Group are removing texture from their ceilings. Textured ceiling tends to collect dust and is hard to clean and paint. Some homeowners swear that their ceilings feel higher after they removed the texture from the ceilings.
However, adding a little texture over a new drywall ceiling can turn a 4-day job into a 2-day job by covering up the seams and errors.
There are several different ways to finish drywall. You can use different techniques and application methods to achieve different looks. Orange peel (also called splatter or eggshell), Mediterranian, and knockdown are all popular designs.
Knockdown is an easy method of finishing a drywall ceiling. It hides the imperfections but doesn’t give the surface a full popcorn finish. This video shows what you need and how to apply a knockdown texture in a couple of different ways.
One article isn’t enough to learn everything about replacing mobile home ceilings but we covered a lot here.
Have you or are you replacing your mobile home ceilings? Have you done a ceiling replacement with sheetrock? We’d love to see and hear from you in our new Facebook group, Mobile Home Living: Remodels and Repair. We’ve managed to get over 3,000 members in just a few months and everyone is so friendly, supportive, and helpful in the group.
As always, thank you so much for reading Mobile Home Living®!
Learn about mobile home additions and understand the pros, cons, and necessary steps for a…
Learn how to paint mobile home walls effectively, overcoming challenges with shiny surfaces and battens…
There're a ton of smart storage hacks to organize your camper on Pinterest and Amazon…
A small bathroom should be beautifully focused on function. Of course there are a few…
Over 100 beautiful manufactured home deck and porch designs plus free design plans and DIY…
If you own an older mobile home with a flat roof or have needed to…
This website uses cookies.